Schneider Electric ALTIVAR 58 TRX Przewodnik Instalacji Pobierz pdf (Strona 16)

Chapter 1—Overview VVDED397047USR6/03

Keypad Display 06/2003

Quick Configuration

First prepare your program settings using the forms beginning on

page 109.

Programming the Altivar 58 TRX controller is facilitated by internal

checks. It is recommended that you access the menus and program

in the following order. All of the steps are not obligatory in all cases.

1. Set the 50/60 Hz switch, (see page 14).

2. Select the language.

3. Select the macro-configuration.

NOTE: 125-500 hp drive controllers have only the variable torque

macro.

4. Select 2 or 3-wire control in the 4—Control menu.

5. Configure parameters in the 3—Drive Configuration menu.

6. Assign the I/O in the 5—I/O menu.

NOTE: If the selected Macro-Configuration is Hdg: Material

Handling, logic input LI4 must be reassigned or unassigned

before you can assign logic input LI3 to a new function.

If the Freewheel Stop / Run Permissive function is assigned to a

logic input, the drive controller will not start the motor unless

that logic input is connected to +24 V.

7. Configure parameters in the 4—Control menu.

8. Configure the switching frequency type in the 3—Drive

Configuration menu.

WARNING

UNINTENDED EQUIPMENT ACTION

• Parameter changes affect drive controller operation.

• Most parameter changes require pressing ENT. Some parameter

changes, such as reference frequency, take effect as soon as

you press the up or down arrow keys.

• Read and understand this manual before using the keypad

display.

Failure to follow these instructions can result in death, serious

injury, or equipment damage.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 125 126

Brak uwag

Schneider Electric ALTIVAR 58 TRX Przewodnik Instalacji Strona 16