
VVDED397047US R8/01 ALTIVAR
58 Keypad Display
08/01 Chapter 2 — Menus
© 1998–2001 Schneider Electric All Rights Reserved
79
7—FILES MENU
The Files menu is accessible when the access locking switch is set to the
position. Changes can only be made when the motor is stopped.
The keypad display can store four drive controller configuration files.
Table 22: 7—File Menu
Parameter Code Description
Factory
Setting
File 1 State
File 2 State
File 3 State
File 4 State
F1S
F2S
F3S
F4S
Displays the state of the corresponding file.
Possible states:
FRE: File free
EnG: A configuration has already been saved in
this file
FRE
FRE
FRE
FRE
Operat. Type
FOt
Allows selection of the operation concerning a file.
Possible operations:
• NO: no operation requested (value by default
each time the keypad display is reconnected to
the drive controller).
• STR: save the configuration in a keypad
display file.
• REC: transfer a file to the drive controller.
• Ini: return the drive controller to factory
settings.
NO
NOTE: The stored program will be substituted for present settings when a file is
transferred to the drive controller.
NOTE: Factory default settings will be substituted for present settings when Ini is
selected and confirmed by pressing ENT twice when prompted.
Password COd See “Access Code” on page 81.
Menu
7
UNINTENDED EQUIPMENT ACTION
• Verify factory default or transferred file settings are compatible
with the application requirements.
• If a stored file is downloaded with the stop key disabled, this file
will be transferred. To stop the motor, an external stop command
must be installed.
Failure to follow these instructions can result in death, serious
injury or equipment damage.
WARNING
Komentarze do niniejszej Instrukcji